POWER CONNECTIONS
To connect to the power supply:
1.Strip at least .50 inch (13 mm) from the power cord to expose the wires.
2.Insert the three wires into the holes in the terminal strip until they snap into place.
3.Confirm that the cord is connected to terminal securely by lightly tugging on the cord.
VIDEO CONNECTIONS
If you are wiring more than one camera to the same transformer, connect one side of the transformer to the same terminal on all cameras, and connect the other side of the transformer to the remaining terminal on all cameras. Failure to connect all of the cameras the same way will cause the cameras to be out of phase with each other and may produce a vertical roll when switching between cameras.
Connect a video cable to the SIGNAL OUT connector (BNC) on the rear of the camera. Refer to Table A for the type of video coaxial cable to use.
Table A. Video Coaxial Cable Requirements
Cable Type* | Maximum Distance |
|
|
RG59/U | 750 ft (229 m) |
RG6/U | 1,000 ft (305 m) |
RG11/U | 1,500 ft (457 m) |
|
|
*Minimum cable requirements: 75 ohms
6 | Pelco Manual |