Troubleshooting, Park Time Minutes | Pelco C1498M-A specification

NOTE: On power-up, the auto scan tilt angle will be whatever angle the camera was at when the right scan limit was set.

NOTE: Preset 1 must be programmed for the dome to park.

SCAN LIMIT STOPS

Refer to the documentation for your control system for programming presets, then do the following:

1.Make sure limit stops are turned ON (refer to the Limit Stops section), then exit the menu.

2.Push the joystick left until you reach the limit you want the camera to go to on the left.

3.Program preset 92 (25).

4.Push the joystick right to the limit you want the camera to go to on the right.

5.Program preset 93 (26).

Setting presets 92 (25) and 93 (26) to the same point disables scan limit stops.

PARK TIME MINUTES

This feature parks the dome at preset 1 after a programmed number of minutes of control inactivity. You can set the time from 1 to 720 minutes (12 hours). Setting the time to zero disables this feature. To change the park time:

1.On the main menu, move the joystick up or down to position the cursor (>) beside Other.

2.Press the Iris Open button to enter the Other submenu.

3.Move the joystick up or down to position the cursor beside Park Time Minutes.

4.Press the Iris Open button. The cursor moves to the right beside the current park time.

5.Move the joystick up or down to change the park time.

6.SELECT – Press the Iris Open button to select your choice.

CANCEL – Press the Iris Close button if you do not want to change the setting.

SCAN SPEED

Scan speed is adjustable from 1-40 degrees per second, and occurs in three scan modes: auto, random, and frame. To change the scan speed:

1.On the main menu, move the joystick up or down to position the cursor (>) beside Other.

2.Press the Iris Open button to enter the Other submenu.

3.Move the joystick up or down to position the cursor beside Scan Speed deg/s.

4.Press the Iris Open button. The cursor moves to the right beside the current number of degrees.

5.Move the joystick up or down to toggle through the number of degrees (1-40) until you reach the number you want. (If set on a low number, the scan will appear to barely move but is still functioning.)

6.SELECT – Press the Iris Open button to select your choice.

CANCEL – Press the Iris Close button if you do not want to change the setting.

TROUBLESHOOTING

NOTE: The dome drive con- tains no user-serviceable parts. If there is a problem with the dome drive, return it to Pelco as a complete unit for servicing.

Symptom: Unit or fan does not operate.

1.Make sure your controller is trying to communicate with the unit and not another camera.

2.Turn off power.

3.Remove the lower dome:

In-Ceiling Models - Insert the flat blade of a screwdriver into one of the slots on the trim ring and twist the screwdriver to pop loose the trim ring and lower dome.

Pendant Models - Remove the two screws that hold the trim ring to the back box. Insert the flat blade of a screwdriver into one of the slots on the trim ring and twist the screwdriver to free the lower dome from the back box.

Pelco Manual C1498M-A (7/99)