Yamaha RX-V640RDS Setting the manufacturer code, Clearing setup manufacturer codes, Notes

REMOTE CONTROL FEATURES

Setting the manufacturer code

You can control other components by setting a manufacturer code. Codes can be set for each of the 9 component controls.

The following table shows factory-set component (Library: component category) and the manufacturer code for each component control.

Component	Component category	Manufacturer	Code
control	(Library)
(buttons)
CD	CD	YAMAHA	0005
MD/CD-R	MD	YAMAHA	0024
TUNER	TUNER	YAMAHA	0003
DVD	DVD	YAMAHA	0098
D-TV/CBL	–	–	–
V-AUX	–	–	–
VCR 1	–	–	–

Clearing setup manufacturer

codes

■Clearing setup manufacturer code for the component control

1 Press an input selector button or ★★ to select the component control for which you want to clear the manufacturer code.

CD MD/CD-R TUNER

DVD D-TV/CBL V-AUX

VCR 1 VCR2/DVR

2 Press CODE SET by using a ballpoint pen or similar object.

The TRANSMIT indicator flashes twice.

VCR 2/DVR	–	–	–
★★	–	–	–

CODE SET

Note

TRANSMIT

1 Press an input selector button or ★★ to select the component you want to set up.

CD MD/CD-R TUNER

DVD D-TV/CBL V-AUX

VCR 1 VCR2/DVR

2 Press CODE SET using a ballpoint pen or similar object.

The TRANSMIT indicator flashes twice.

TRANSMIT

CODE SET

3 Press the numeric buttons to enter the four digit manufacturer’s code for the component to be used.

Refer to “LIST OF MANUFACTURER’S CODES”

at the end of this manual.

HALL	JAZZ CLUB	ROCK	ENTER-
		CONCERT	TAINMENT
1	2	3	4
MUSIC	TV	MOVIE	MOVIE
VIDEO	THEATER	THEATER 1 THEATER 2
5	6	7	8
/DTS	NIGHT	6.1/5.1	STEREO
SUR.
9	0	+10	ENTER

EFFECT

The TRANSMIT indicator flashes twice.

Notes

•If the manufacturer of your component has more than one code, try each of them until you find the correct one.

•If you wait for more than 30 seconds during step 3, the setup process cancels. If this happens, start again from step 2.

•If you do not press any button within 30 seconds after step 2, the clearing process cancels. If this happens, start again from step 1.

3 Enter the code number “0000”.

The TRANSMIT indicator flashes twice, and the manufacturer code for the selected component is cleared.

y

•You can clear all setup manufacturer codes at once by entering the code number “9990”.

48