8.2.7.1. MOTION
When there is movement of the subject on the screen there will be an alarm, or the user will be informed through com- munications on “MD” will display on the screen.
NOTE: There is a signal every time there is move-
ment by the subject. If motion is detected, MD (Motion Detector) is displayed on the upper left of the screen.
Caution: An error can occur in the motion detection func- tion in the following cases:
When lighting is unsteady
When light changes often even though there is no movement of the subject.
Note: It is recommended that this function should be used after setting the detection sensitivity and the zone state after videoing the environment for an extended time.
| MOTION |
ZONE SELECT | CENTER |
ZONE STATE | OFF |
SENSITIVITY | 8 |
INITIAL | OFF |
EXIT |
|
ZONE SELECT
Zone can be set to UPPER, RIGHT, CENTER, or WHOLE detection field as shown.
UPPER
LEFT CENTER RIGHT
LOWER
SENSITIVITY
Sets sensitivity to detect movement from 1 (low) to 15 (high).
MENU
FOCUS EXPOSURE BLC WHITE BAL 3D-DNR SPECIAL
GENERAL INITIAL EXIT
14