EverFocus user manual EDN800 Maintenance, Browse

Page 40

EDN800

3.7.4 Maintenance

Maintenance Server

Reboot: The unit is rebooted without changing any of the settings. Use this method by pressing Reboot button if the unit is not behaving as expected.

Restore: The unit is restarted and most current settings are reset to the factory default values by pressing Restore button. The only settings saved are:

•IP setting

•DDNS setting

Default: The Default button should be used with caution. Pressing this button will return all of the camera's settings, including the IP address, to the factory default values. The camera will then have to be re-installed.

Save/Load Configuration Server

To take a backup of all of the configurations, press Save to save all configurations to a config. file. If necessary, it is then possible to return to the previous settings if the settings are changed and there is unexpected behavior.

Press the

Browse

button to locate the saved config. file (see above) and then click

40

Page 39 Page 41
Image 40
Page 39 Page 41
Contents
EDN800 User’s Manual Page Safety Notice About this documentTerms and Trademark SupportTable of Contents Introduction Operation Window EDN800 EDN800 Setting EDN800 Information 2 LogUser Config EDN800 EDN800 Network IP TypePassword IP addressSubnet Mask GatewayHttp Port DdnsBandwidth SMTP/FTP EDN800 EDN800 EDN800 Network Alarm reserved for PowerCon Video Multi StreamingEDN800 Image setting EDN800 CameraEDN800 User Event EDN800 Event EDN800 Motion Alarm Time Mask System EDN800 Date/Time EDN800 EDN800 Daylight Saving SD Card Indication Description EDN800 Maintenance BrowseEDN800 Specifications Head Office USA L.A. Office USA N.Y. Office Europe OfficeChina Office Japan Office