EverFocus EDN800 user manual Alarm

Page 32

EDN800

There are 5 motion trigger areas, which can be distinguished by 5 different colors. Check Enable checkbox to enable event action.

For each of them, you can set the event action to be activated. Event action can be set in “Event” section.

Moreover, you can set the Sensitivity level for motion triggered by selecting from 1 (low), 2, 3, 4, 5, 6, 7, 8, 9 to 10 (high).

3.6.3 Alarm

Alarm Output Setting

Contact Type: Normal Close, Normal Open

Duration Time: Select duration time of alarm output from 5 sec, 10 sec, 20 sec, 30 sec, 60 sec, 2 min, 3 min and 5 min.

Press Apply to apply the setting changes or Reset to reset without saving the change.

Pre/Post Alarm Setting

This function is used to check what happened immediately before and after a trigger, e.g. 5 seconds before or after a motion has been detected.

Pre-Alarm Buffer: Image saved internally in the server from the time immediately preceding the trigger. Input the desired length of pre-trigger buffer time. It can be

32

Page 31 Page 33
Image 32
Page 31 Page 33
Contents
EDN800 User’s Manual Page Safety Notice About this documentTerms and Trademark SupportTable of Contents Introduction Operation Window EDN800 EDN800 Setting EDN800 Information 2 LogUser Config EDN800 EDN800 Network IP TypePassword IP addressSubnet Mask GatewayHttp Port DdnsBandwidth SMTP/FTP EDN800 EDN800 EDN800 Network Alarm reserved for PowerCon Video Multi StreamingEDN800 Image setting EDN800 CameraEDN800 User Event EDN800 Event EDN800 Motion Alarm Time Mask System EDN800 Date/Time EDN800 EDN800 Daylight Saving SD Card Indication Description EDN800 Maintenance BrowseEDN800 Specifications Head Office USA L.A. Office USA N.Y. Office Europe OfficeChina Office Japan Office