Camera Settings
Note: These steps are already done in manufacturing, but you may need to reset these setting if the camera is used in an automatic mode for other photography.
A. Lens Settings – Nikkor 105mm VR Lens
1.Put the lens in Manual Focus Mode
a.Set the top lens setting to M (to the right, toward the lens mount). The lens is fixed at minimum focus and must always remain so fixed (closest focus is 0.314 m, 1:1).
b.Black plastic tape is in place to keep this minimum focus set.
2.The middle switch can be in either position (FULL or
a.Black plastic tape is in place to keep this switch set correctly.
b.This setting is not critical
3.Put the lens in
a.The bottom switch for VR should be set off (to the right, toward the lens mount).
b.Black plastic tape is in place to keep this switch set correctly.
B. Camera Menu Settings – Nikon D60
4.Put the camera in Manual Flash Mode:
a.With camera switched on, press the Menu button
b.In the left column are four icons:
i.Playback Menu (a
ii.Shooting Menu (camera icon)
iii.Custom Setting Menu (pencil icon)
iv.Set Up Menu (wrench icon)
v.Retouch Menu (paintbrush icon)
c.Select the Custom Setting Menu by pressing the
d.Move up or down the submenu with the up or down arrow on the command disc
e.Select 14 –
f.Enter the submenu by pressing the
g.Select M Manual Flash, then press the right arrow for OK
h.Select Full power, then press the right arrow for OK
5.Set the camera’s White Balance to Flash:
a.Press left arrow to go to left vertical Navbar and select the second icon (camera) for Shooting Menu
b.Press Right Arrow and then the Down arrow; go down to “White Bal”
c.Enter the submenu by pressing the
d.Press Down Arrow until “Flash” is highlighted, then Press Right Arrow twice for OK
6.Press the Menu button twice to exit all menus.
7.If you have further questions, please contact Jon Miles at jon@milesresearch.com
Use of Iris Camera | 20 |