Yamaha HTR-6150 Setting remote control codes, 78 En, Remote control code default settings

Remote control features

Setting remote control codes

You can control other components by setting the appropriate remote control codes. For a complete list of available remote control codes, refer to “List of remote control codes” at the end of this manual.

Remote control code default settings

Input	Component	Manufacturer	Default
source	category		code
CD	CD	Yamaha	5013
MD/CD-R	CD-R	Yamaha	5001
TUNER	TUNER	Yamaha	5007
DVD	DVD	Yamaha	2000
DTV/CBL	—	—	—
V-AUX	TUNER	Yamaha	5011
DVR	DVR	Yamaha	2011
XM	TUNER	Yamaha	5009
SIRIUS	TUNER	Yamaha	5017
A	TUNER	Yamaha	5012
B	TUNER	Yamaha	5009
C	TUNER	Yamaha	5017

Note

You may not be able to operate your Yamaha component even if a Yamaha remote control code is preset as listed above. In this case, try setting another Yamaha remote control code.

1While pressing and holding one of the input selector buttons (4) on the remote control to

select the input area you want to set up, press 2AV POWER for more than 3

seconds.

A	XM	SIRIUS
CD	MD/CD-R	TUNER
			POWER
DVD	DTV/CBL	DVR	AV
V-AUX/DOCK	B	C	Press for 3

seconds

While holding down

2Press the numeric buttons (0 to 9) (G) to enter the four-digit remote control code for the component to be used.

When the setting succeeds, “RemoteSetup OK” appears; however, when it does not, “RemoteSetup NG” appears in the front panel display.

Notes

•If the manufacturer of your component has more than one code, try each of them until you find the correct one.

•If you do not press any buttons within 30 seconds in step 2, the setup process is canceled. If this happens, repeat the setup procedure.

78 En