Yamaha HTR-5835 Front speakers FR and FL, Center speaker C, Surround speakers SR and SL

The speaker layout below shows the standard ITU-R* speaker setting. You can use it to enjoy CINEMA DSP

and multi-channel audio sources.

*ITI_T-R is" the radio conmmnication sector of the ITU (International Teleconmmnication Union).

\

Front speakers (FR and FL)

The front speakers are used for the main source sound plus effect sounds. Place these speakers an equal distance fi'om the ideal listening position. The distance of each speaker from each side of the video monitor should be the same.

Center speaker (C)

The center speaker is for the center channel sounds (dialog, vocals, etc.). If for some reason it is not practical to use a center speaker, you can do without it. Best results, however, are obtained with the full system. Align the fi'ont face of the center speaker with the front face of your video monitor. Place the speaker centrally between the front speakers and as close to the monitor as possible, such as directly over or under it.

Surround speakers (SR and SL)

The sun'ound speakers are used for effect and surround sounds. Place these speakers behind your listening position, facing slightly inwards, about 1.8 m (6 ft) above the floor.

Subwoofer

The use of a subwoofer, such as the YAMAHA Active

Servo Processing Subwoofer System, is effective not only

for reinforcing bass frequencies fi'om any or all channels,

but also for high fidelity reproduction of the LFE (low-

frequency effect) channel included in Dolby Digital and DTS software. The position of the subwoofer is not so critical, because low bass sounds are not highly

directional. But it is better to place the subwoofer near the fi'ont speakers. Turn it slightly toward the center of the room to reduce wall reflections.

11