Nikon EL2 instruction manual Preparation for USE, Installing the Battery

Page 8

PREPARATION FOR USE

Installing the Battery

The exposure measurement and shutter control circuits of the EL2 are powered by a single 6-volt (type 544) battery mounted in the battery chamber at the bottom of the mirror box. To install the battery, first remove the lens (if mounted) from the camera body (see page

42)and lock up the mirror (turn the lockup lever upward as far as it will go, as described on page 39) to gain access to the battery chamber. Then, open the battery chamber (slide the lid to the left, then up) and install the battery, making sure to properly align the positive (+) and negative (-) terminals of the battery as depicted on the interior of the lid. After

inserting and properly seating the battery, snap the chamber lid shut, unlock the mirror and remount the lens preparatory to shooting.

Caution: Should the battery be installed incorrectly (i.e., in the reverse direction) in the chamber, its energy will be depleted in a matter of minutes; thus, take extra care to insert the battery properly. Also, be careful not to touch the shutter curtain and mirror surface while installing the battery.

Note: Remove the battery when the camera is not to be used for a long period; this will prevent leakage within the camera. Also, keep the camera as warm as possible when operating under cold-weather conditions; otherwise, the battery may fail to function. (See "Tips on Camera Care" on page 40 for additional information.)

Image 8
Contents Nikon Nomenclature Frame counter Brief Guide to Camera Handling Page Contents Foreword Installing the Battery Preparation for USERemoving the Battery Preparation for USE Prior to Shooting Setting the Film Speed Operation of Camera ControlsSetting the Shutter Speed Film-Advance Lever Setting the ApertureOperation of Camera CON Frame Counter Shutter Release Button LockOperation of Camera Controls Unloading Film Holding the Camera Shutter Release Operation Operation via Cable ReleasePage Out of focus Focus Focusing Infrared PhotographyDepth of Field Depth of Field Page Exposure Measurement MEn j Exposure Measurement Manual Shutter Speed SelectionAmount of light reaching the film plane is deter Metering Range Metering with a bright area in the center will STOP-DOWN Exposure Measurement 0T\ For automatic diaphragm lenses with no coupling ridgeExposure Compensation Adjustments B4WEV Range of the Camera Auto exposure control at full apertureHow to read the EV range chart Full-aperture meteringSection C Flash Synchronization NikonMirror Lockup Tips on Camera Care Page Changing the Lens Coupling Lever Lock/Release Operation Accessories Auto Winder AW-1Page FEATURES/SPECIFICATIONS Page Nippon Kogaku K.K