Power Button
(Fig. 28)
Light Operation
LED Window
Post Dive Cleaning
1)After each dive, you should dunk the lights and pods in fresh water.
2)Press the red button to flush out any water.
3)After you are geared down and completely dried off, simply towel dry the lights in a safe dry place.
Do not leave your lights in the rinse bucket with other equipment. Underwater gear has been known to be damaged by jostling against other products.
Storage
Before you turn on the Pro lights, verify that the mode selector (flat position of black ring around red power button) is set to the P setting.
Before you turn on the Elite lights, verify that the mode selector (flat position of black ring around red power button) is set to the E setting.
Operation with SunRay-X Pro Lighting System
Pro lights can be operated either by the Pod Power Button or from the Smart Grip controls.
Operation from Smart Grips
1)Activate initial power up by pressing the Pod Power Button. (Refer Fig 28). After initial power up lights may be controlled using LIGHT button on the Smart Grip controls.
2)Turn off lights by pressing the LIGHT button.
Operation from Battery Pods
1)Turn on light by pressing the Power Button on the rear cap (Refer Fig 28).
2)Turn off light by pressing the Power Button on the rear cap.
Operation with SunRay-X Elite Lighting System
Elite lights can be operated either by the Pod Power Button or from the Smart Grip controls.
Operation from Smart Grips
1)Activate initial power up by pressing the Pod Power Button. (Refer Fig 28).
2)Use the LIGHTS button to cycle through power settings.
3)Turn off lights by pressing and holding the LIGHT button for three seconds.
Operation from Battery Pods
1)Turn on light by pressing the Power Button on the rear cap (Refer Fig 28).
2)Press the red button again to change the light output level.
3)Turn off light by holding the red button down for three seconds.
After diving remove your batteries and charge them. Leaving your batteries discharged will significantly reduce the life of the battery. Store as you would any other valuable piece of electronic equipment.
Other Maintenance
•Apply a light film of
•We highly recommend a factory annual service to maintain proper operation of your SunRay Lights.
•If a battery pod is flooded, immediately remove the battery, and rinse the pod with fresh water. Most
22 | 23 |