Bluefin VX2000 Lights Getting Started

(Fig. 15)

(Fig. 16)

Bluefin VX2000 Lights - Getting Started

Pictured below are the components of both the SunRay -X Pro and the SunRay -X Elite lighting systems. Take a moment to familiarize yourself with each part for later identification and use.

	Charger and
Light Cable	electrical cord

Battery Pods

6)Press the Handle Cap into the handle assembly so O-ring seals evenly.

7)Replace both hex screws in Handle Cap and tighten using hex key.

Smart Grip O-ring and Battery Kit (part # 802-0117) (ref. fig. 16) Kit contains one O-ring and battery set for one Smart Grip.

Reversing Smart Grip left and right functionality

Smart Grips can be programmed to swap left and right button functions. This is useful if a Smart Grip battery becomes exhausted during a dive. You then can swap Smart Grip functions to maintain primary housing operation.

This is a total button function swap, not a button by button nor a custom configuration.

Pod Locker

Light Arms

NiMH Batteries

1)Press either FAR/- and NEAR/+ or TELE and WIDE simultaneously and hold for three seconds.

Button functions are now swapped. New button configuration will mirror old configuration, i.e. REC and PHOTO, AF/OFF and PHOTO DIS.

This is a handle-by-handle procedure. Performing this function on one handle will not switch both.

Revert to original button configuration

1)Perform the same swap procedure. Press either FAR/- and NEAR/+ or TELE and WIDE simultaneously and hold for three seconds.

Eventually the batteries in the Smart Grips will totally exhaust. Contact Light & Motion to order a replacement battery and O-ring kit (part #802- 0117). Or remove the Smart Grip handle cover and Replace the two batteries located inside. Batteries are CR 1/3 N and can usually be purchased from any store that stocks camera and watch batteries.

Pro light heads

Charger and electrical cord

Battery Pods

Light Arms

NiMH Batteries

Pod Locker

Elite light heads