Kodak M1093 IS manual Using the framing marks to take pictures, Using the optical zoom

Taking pictures/videos

Using the framing marks to take pictures

Framing marks indicate the camera focus area. In Smart Capture mode (and in SCN modes designed for pictures of people), the camera attempts to focus on faces.

1Press the Shutter button halfway.

If the camera is not focusing on the desired subject, release the Shutter button and recompose the scene.

2Press the Shutter button completely down to take the picture.

Framing marks

NOTE: Multiple framing marks may appear when faces are detected. (The primary face gets a yellow

framing mark. To change focus from the selected face to another face, press .) Framing marks do not appear in all modes.

Using the optical zoom

1Use the LCD to frame your subject.

2To zoom in, press Telephoto (T).

To zoom out, press Wide Angle (W).

3Take the picture or video.

NOTE: For focus distances, see Specifications starting on page 52.

Using digital zoom

Use digital zoom in any picture-taking mode to get up to 5X magnification beyond optical zoom. Press Telephoto (T) until the slider is at the end of the optical zoom range. Release Telephoto (T), then press it again.

NOTE: Digital zoom is not available in Smart Capture mode. You may notice decreased image quality when using digital zoom. The slider pauses and turns red when the picture quality reaches the limit for an acceptable 4 x 6-in. (10 x 15 cm) print. You cannot use digital zoom while taking a video.

6 www.kodak.com/go/support