Kodak CD43 manual Camera ready light status

Troubleshooting

If...	Try one or more of the following
Picture is too light	■ Reposition camera to reduce the amount of available light.
	■ Turn flash off (page 25).
	■ Move so that the distance between you and the subject is within the
	effective flash range (page 9).
	■ To automatically set exposure and focus, press the Shutter button
	halfway. When the Ready light glows green, press the Shutter
	button completely down to take the picture.
	■ Use Auto, Landscape, or Close-up to adjust the exposure
	compensation.
Picture is not clear	■ To automatically set exposure and focus, press the Shutter button
	halfway. When the Ready light glows green, press the Shutter
	button completely down to take the picture.
	■ Clean the lens (page 58).
	■ Make sure camera is not in Close-up mode if you are more than
	27.6 in. (70 cm) from your subject.
	■ Place the camera on a flat, steady surface or use a tripod, especially
	in high-zoom settings or in low light.

Camera ready light status

If...	Try one or more of the following
Ready light does	■ Turn on the camera (page 2).
not turn on and the	■ Recharge the battery or install a new one (page 1).
camera does not	■ Mode dial was on when battery was reloaded. Turn Mode dial off, then
work	back on.
Ready light blinks	■ Picture is being processed and saved to the camera. Camera is
green	operating normally.
	■ Camera is connected. Camera is operating normally.
Ready light blinks	■ Recharge the battery or install a new one (page 1).
red and camera
turns off
44	www.kodak.com/go/support