Kodak Z1485 IS manual Troubleshooting

	Troubleshooting
If	Try one or more of the following
In Review mode, a	■ Transfer the picture to the computer (page 44), then format the card or
blue or black	internal memory (see page 33).
screen is displayed	Caution: Formatting a card deletes all pictures and videos,
instead of a	including protected files.
picture.
Shutter button	■ Turn on the camera (page 2).
does not work.	■ Wait until the Ready light stops blinking red before attempting to take
	another picture.
	■ Transfer pictures to the computer (page 44), delete pictures from the
	camera (page 15), switch image storage locations (page 30), or insert
	a card with available memory (page 3).
Slide show does	■ Adjust the camera Video Out setting (NTSC or PAL, see page 32).
not run on external	■ See the external device’s user’s guide.
video device.
Picture is too light.	■ Move so there is at least 2 ft (0.6 m) between the camera and the
	subject.
	■ Decrease Exposure Compensation (page 38).
Picture is not clear.	■ Clean the lens (page 61).
	■ Make sure your camera is not in Close-up mode.
	■ Move so there is at least 2 ft (0.6 m) between the camera and the
	subject.
	■ Press the shutter button halfway to focus and set exposure. When the
	ready light turns green, press the Shutter button completely down.
	■ Place the camera on a flat, steady surface or use a tripod.
Picture is too dark.	■ Turn on the flash (page 9).
	■ Move so there is no more than 11.8 ft (3.6 m) in wide angle and
	6.9 ft (2.1 m) in telephoto between the camera and the subject.
	■ Use Fill flash (page 9) or change your position so light is not behind
	the subject.
	■ Increase Exposure Compensation (page 38).
www.kodak.com/go/support		49