Yamaha AV Receiver owner manual Switching library codes, Clearing set up remote control codes

REMOTE CONTROL FEATURES

Switching library codes

You can select the unit you want to operate with the remote control by entering the library code.

1Press CODE SET using a ballpoint pen or similar object.

The TRANSMIT indicator on the remote control blinks twice.

TRANSMIT

CODE SET

Clearing set up remote control codes

1Press an input selector button or / to select the component control for which you want to clear the remote control code.

CD MD/CD-R TUNER SLEEP

DVD	DTV/CBL	V-AUX	MULTI CH IN
VCR			AMP

2Enter the code number “9991” or “9992” (see the table below).

The TRANSMIT indicator on the remote control blinks twice, and the library code is changed.

AMP library		Remote
code
		control ID
(remote	Function
		(unit setting:
control
		see page 64)
setting)
9991	To operate this unit using	ID1
	the default code.	(initial setting)
9992	To operate this unit using	ID2
	an alternative code.

When using multiple YAMAHA receivers/amplifiers, you may be able to operate the other components simultaneously with the default code setting. In this case, set one of the alternative codes to operate this unit separately.

Note

You must also make settings for the receiver/amplifier.

2Press CODE SET using a ballpoint pen or similar object.

The TRANSMIT indicator on the remote control blinks twice.

TRANSMIT

CODE SET

3Enter the code number “0000”.

The TRANSMIT indicator on the remote control blinks twice, and the remote control code for the selected component is cleared.

y

•If you do not press any button within 30 seconds after step 2, the clearing process is canceled. If this happens, start over from step 1.

•You can clear all setup remote control codes at once by entering the code number “9990”.

68