Yamaha AV Receiver Specifications, Audio Section, Video Section, Fm Section, Am Section, General

Page 88
SPECIFICATIONS

SPECIFICATIONS

AUDIO SECTION

Minimum RMS Output Power for Front, Center, Surround, Surround back

20 Hz to 20 kHz, 0.06% THD, 8

90 W

Maximum Power (EIAJ)

[Asia, Korea and General models]

1 kHz, 10% THD, 8

130 W

• Dynamic Power (IHF)

 

8/6/4/2

120/155/190/235 W

• DIN Standard Output Power [U.K. and Europe models]

1 kHz, 0.7% THD, 4

135 W

• IEC Output Power [U.K., Europe and Asia models]

1 kHz, 0.06% THD, 8

100 W

• Damping Factor (IHF)

 

20 Hz to 20 kHz, 8

120 or more

• Frequency Response

 

CD terminal to Front L/R

10 Hz to 100 kHz, –3 dB

• Total Harmonic Distortion

CD, etc. to Front L/R (20 Hz to 20 kHz, 40 W, 8 Ω)

................................................................................

0.06% or less

• Signal to Noise Ratio (IHF-A Network)

 

CD (250 mV) to Front L/R, Effect Off

100 dB or more

• Residual Noise (IHF-A Network)

 

Front L/R

150 µV or less

• Channel Separation (1 kHz/10 kHz)

 

CD (5.1 kterminated) to Front L/R

60 dB/45 dB or more

• Tone Control (Front L/R)

 

BASS Boost/Cut

±10 dB/60 Hz

TREBLE Boost/Cut

±10 dB/20 kHz

• Phones Output

150 mV/100

• Input Sensitivity/Input.................................................................Impedance

200 mV/47 k

CD, etc.

MULTI CH INPUT

200 mV/47 k

• Output Level/Output..............................................................Impedance

200 mV/1.2 k

REC OUT

SUBWOOFER

4 V/1.2 k

ZONE 2 OUTPUT

[U.S.A., Canada, Australia, U.K. and Europe models]

............................................................................ 200 mV/1.2 k

VIDEO SECTION

• Video Signal Type

PAL/NTSC

• Signal to Noise Ratio

50 dB or more

• Frequency Response (MONITOR OUT)

 

Composite, S-video

5 Hz to 10 MHz, –3 dB

Component

5 Hz to 60 MHz, –3 dB

FM SECTION

• Tuning Range

 

[U.S.A. and Canada models]

.......................... 87.5 to 107.9 MHz

[Asia and General models]

87.5/87.50 to 108.0/108.00 MHz

[Other models]

87.50 to 108.00 MHz

• Usable Sensitivity (IHF)

1.0 µV (11.2 dBf)

• Signal to Noise Ratio (IHF)

 

Mono/Stereo

76 dB/70 dB

• Harmonic Distortion (1 kHz)

 

Mono/Stereo

0.2%/0.3%

• Stereo Separation (1 kHz)

42 dB

• Frequency Response

20 Hz to 15 kHz, +0.5, –2 dB

AM SECTION

• Tuning Range

 

[U.S.A. and Canada models]

.............................. 530 to 1710 kHz

[Asia and General models]

530/531 to 1710/1611 kHz

[Other models]

531 to 1611 kHz

• Usable Sensitivity

300 µV/m

GENERAL

• Power Supply

 

 

[U.S.A. and Canada models]

AC 120 V, 60 Hz

[Australia model]

AC 240 V, 50 Hz

[Korea model]

AC 220 V, 60 Hz

[U.K. and Europe models]

.................................

AC 230 V, 50 Hz

[General model]

AC 110/120/220/230240 V, 50/60 Hz

[Asia model]

AC 220/230240 V, 50/60 Hz

• Power Consumption

 

 

[U.S.A. and Canada models]

350 W/440 VA

[Other models]

360 W

• Standby Power Consumption

......................................

0.1 W or less

• AC Outlets

 

 

[U.K. and Australia models]

1 (Total 100 W maximum)

[U.S.A. and Canada models]

2 (Total 100 W maximum)

[Europe, Asia and General models]

2 (Total 50 W maximum)

• Dimensions (W x H x D)

435 x 171 x 420 mm

 

 

(17-1/8” x 6-3/4” x 16-1/2”)

• Weight

11 kg (24 lbs 4 oz)

84

Image 88
Contents AV Receiver RX-V557OWNER’S MANUAL IMPORTANT SAFETY INSTRUCTIONS Explanation of Graphical SymbolsFCC INFORMATION for US customers Note to CATV system installerWe Want You Listening For A Lifetime CAUTION: READ THIS BEFORE OPERATING YOUR UNITFOR CANADIAN CUSTOMERS CONTENTS FEATURES Built-in 6-channelpower amplifierSound field features Other featuresSupplied accessories Installing batteries in the remote controlGETTING STARTED Notes on batteriesFront panel CONTROLS AND FUNCTIONSA B C D E F G H 9VOLUME 0PHONES SILENT CINEMA jackASPEAKERS A/B CSTRAIGHT EFFECTRemote control Using the remote control Handling the remote controlFVOLUME +/– CSLEEPFront panel display J K LK96/24 indicator LLFE indicatorMInput channel indicators/speaker indicators NZONE 2 indicatorAsia and General models only Rear panel8 9 0 A SPEAKER SETUP Speaker placementSurround speakers SR and SL Surround back speaker SB5 Tighten the knob to secure the wire Speaker connectionsBanana plug connections 3Unscrew the knobFRONT terminals CENTER terminalsSURROUND terminals SUBWOOFER jackBefore connecting components CONNECTIONSCable indications Analog jacksConnecting video components Connections for DVD playbackVideo in monitorConnecting to the MULTI CH INPUT jacks NotesConnections for other video components game console or video camera, to this unitVIDEO AUX jacks on the front panel NotesConnecting audio components Connections for audio componentsAudio out Coaxial outConnecting the AM loop antenna Connecting the FM and AM antennasNotes Connecting the AC power cord AC OUTLETS SWITCHEDVOLTAGE SELECTOR Asia and General models only Memory back-upSpeaker impedance setting Turning on the power4Press STANDBY/ON to turn off the power Be sure this unit is in the standby modeBASIC SETUP Using the BASIC SETUP menu3Press ENTER to enter BASIC SETUP 4Press j / i to select the desired setting>SET CANCEL 9Press d to display SET/CANCEL10Press j / i to select the desired setting 12Press j / i to select the desired settingFR ----|| C ----||SL ----|| SB ----||6Adjust the volume to the desired output level PLAYBACKBasic operations 4Select the input sourceTo listen with headphones “SILENT CINEMA” To adjust the toneTo mute the sound 7Select a sound field program if desiredTV Sports Selecting sound field programsMULTI CH INPUT Selecting MULTI CH INPUTRemote control operation Enjoying multi-channelsoftwareTo select a decoder, press j / i repeatedly while PLIIxMusic etc. is displayedEnjoying 2-channelsoftware in surround When you select the SUR. STANDARD programNotes Press j / i to adjust the effect level while DIRECT STEREOEffect.Lvl:MID Listening to high fidelity stereo soundListening to unprocessed input signals 2ch StereoSTRAIGHT Downmixing to 2 channelsSelecting input modes Displaying information about the input source1Rotate INPUT to select the input source 1Select the input sourceFormat FM/AM TUNING Automatic and manual tuningAutomatic tuning 3 2 4 1Presetting stations Manual tuningAutomatically presetting FM stations 1Press FM/AM to select the FM bandManually presetting stations Automatic preset tuning options3 4 2,5 1Tune into a stationSelecting preset stations panel display with the presetfrequency appear in the front group and number you have1Select preset station “E1” Exchanging preset stations2,4 1,3 1,3 A/B/C/D/E l PRESET/TUNING/CH h 4Press PRESET/TUNING EDIT againPRESET/TUNING EDIT XM SATELLITE RADIO TUNING What is XM Satellite Radio?Connecting the XM Connect and Play digital antenna accessoryXM Satellite Radio functions Remote control functionsFront panel functions 3 Press PRESET/TUNING/CH l / h or PRESET/CH u / d on the remote control toActivating XM Satellite Radio XMRADIOSwitching XM information When the channel number/name is displayedWhen the channel category is displayed When the artist name/song title is displayedXM Satellite Radio search modes ALLCHSEARCHAll Channel Search mode PRESETSEARCH Preset Search modeCATSEARCH Category Search modeDirect Number Access mode ALL CH SEARCH<XM> <XM>123Setting XM Satellite Radio preset channels C040DeepC5040Deep 040DeepTraC5:040Deep XM SATELLITE RADIO TUNINGRemote control Front panelStatus and error messages NO SIGNALCHECK ANTENNA UPDATINGSpecial considerations when recording RECORDINGDTS software 4Start recording on the recording componentFor movie/video sources SOUND FIELD PROGRAM DESCRIPTIONSNotes MOVIE THEATER For music sources Using the sleep timer Setting the sleep timerCanceling the sleep timer ADVANCED OPERATIONS3Press j / i to adjust the speaker output level Manually adjusting speaker levels1Press AMP BASIC SETUP MANUAL SETUPSET MENU 1 SOUND MENUUsing SET MENU MANUAL SETUP3Press u / d to display MANUAL SETUP 8To exit, press SET MENU when finishedSpeaker settings ASPEAKER SET Subwoofer phase SWFR PHASE1 SOUND MENU Front speakers FRONTSpeaker level BSP LEVEL Speaker distance CSP DISTANCECenter graphic equalizer DCENTER GEQ Low-frequencyeffect level ELFE LEVELAudio settings GAUDIO SET 2 INPUT MENUInput/output assignment I/O ASSIGN Muting type MUTE TYPDisplay settings ADISPLAY SET 6To exit, press SET MENU when finished3 OPTION MENU 2Press AMPXM Radio setting EXM RADIO SET Speaker B setting SP BParameter initialization CPARAM. INI XM Radio antenna XM ANT4Press STANDBY/ON to confirm your selection ADVANCED SETUP MENUSTANDBY/ON ADVANCED SETUP menu items Factory presets PRESETSpeaker impedance SP IMP Remote REMOTEREMOTE CONTROL FEATURES Control areaControlling this unit Controlling other componentsSetting remote control codes Remote Control Code Default SettingsNotes Notes7 8 9 Controlling other componentsB C D Clearing set up remote control codes Switching library codes3Enter the code number “0000” System configuration and connections example ZONE 2 U.S.A., CANADA, AUSTRALIA, U.K. AND EUROPEMODELS ONLY Zone 2 connectionsRemote controlling Zone To enable Zone 2 mode on the remote control1Press to set the remote control to Zone 2Press SYSTEM POWER to turn Zone 2 power onFor DVDs encoded in DTS Special considerations for DTS softwareFor CDs encoded in DTS What is a sound field Changing parameter settingsEDITING SOUND FIELD PARAMETERS Elements of a sound fieldResetting parameters to the factory presets Memory back-upSOUND FIELD PARAMETER DESCRIPTIONS DSP LEVEL DSP levelINIT.DLY Initial delay For 2ch Stereo DIRECT DirectDIMENSION Dimension For 6ch StereoCT LEVEL Center level SL LEVEL Surround left levelTROUBLESHOOTING GeneralPage 14-18 Remote control TunerBe sure this unit is in standby mode RESETTING THE FACTORY PRESETS4Press STANDBY/ON to confirm your selection GLOSSARY Audio formatsDolby Digital Dolby Digital EXSound field programs Audio informationCINEMA DSP SILENT CINEMAVideo signal information Component video signalComposite video signal S-videosignalSPECIFICATIONS AUDIO SECTIONVIDEO SECTION FM SECTIONLIST OF REMOTE CONTROL CODES APPENDIX-iCABLE TV APPENDIX-iiSATELLITE TUNER APPENDIX-iii CD PLAYERDVD PLAYER DVD RECORDERTAPE DECK 2005All rights reserved Printed in Malaysia