Swann SW211-WIP, SW111-WIP user manual

Page 14

3.In the pop-up Add New Camera dialog window, you can:

zSelect the Search tab if you are not sure of the camera’s IP address. Click Search camera to search the available camera within the network. Once the camera is found and is shown in the list, select it and click Add Camera.

zSelect the Input tab to add a camera by entering its IP address directly. Enter the camera’s IP address (default: 192.168.0.30) and Port (default: 80), and then click Add Camera.

- 13 -

Image 14

Contents IP-3G ConnectCam 1000 Wireless Network Camera Contents Introduction Hardware RequirementInstallation Page Page Using Ultra View To launch the programItem features „ Controls Panel„ View Selection Panel „ Camera Panel „ System Panel „ PAN-TILT Control Panel optional„ Video View Window and Camera List To add a camera Click Add New CameraPage Page To remove a camera To link to the Web page of the cameraTrigger recording by motion detection To record videoManual recording Schedule recording To configure the recording settings Page To playback the recorded video To set up motion detection options Page Information