2.3.4Date Setting
This section tells you how to setup IP device’s date and time settings.
zSTEP 1: Click the [Date Setting] on the “Main Setup page”. The “Date setting page” is displayed as below
zSTEP 2: Configure these settings with reference to the table below. If you are still unsure what to set, contact your system administrator.
■Date Setting
Parameters | Description |
| Click this to enable IP device’s SNTP/NTP function. |
| SNTP/NTP function enables this video to synchronize its time |
| settings with a SNTP/NTP server. You can use this function to |
| make sure all your IP devices’ time is the same. Additionally, |
SNTP/NTP | with our embedded |
tell the event sequence accurately. | |
server | IP address: Enter the IP address of the SNTP/NTP |
| |
| server. |
| Sync time: Select the time interval for this IP device |
| to synchronize its time. |
| Click this to manually setup the date & time. |
Set manually | Date : Select the date |
| Time: Select the time |
Time zone | Select the time zone offset for local settings |
| |
Day Light Saving | Select Type 1 to specify daylight saving time by week |