If, however, there is still output from the amplifier when the car stereo volume control is at its minimum setting, or the output level increases too fast with a small rotation of the volume control, adjust the Level control to decrease the output from the system.
Once the correct setting is found, these controls should not require any further adjustment.
6HPF Crossover Frequency Control
This Control selects the crossover frequency when the Sub woofer Crossover Selector 4 is in the "HPF" setting. Adjust it to the appropriate position for the characteristics and crossover frequency requirements of the speaker system with which the amplifier is being used.
4Sub-Woofer Crossover Selector
This switch allows selection of the frequency filters that permit the amplifier to be used to reproduce the entire audio range or just the bass range.
In the "FULL" position of the switch, the response is flat and unaffected so the entire audio frequency range is reproduced by the amplifier. Use this setting if the amplifier is being used to power a full range speaker system.In the "LPF"
7Bass Boost Frequency Control
Allows the addition of up to +18dB increase in sound level in lower frequencies (0~18dB).
8Fuse
The circuitry of the amplifier is protected from damage by an
5LPF Crossover Frequency Control
This Control selects the crossover frequency when the Sub woofer Crossover Selector 4 is in the "LPF" setting.Adjust it to the appropriate position for the characteristics and crossover frequency requirements of the speaker system with which the amplifier is being used.