Polycom 70 manual Important Note About Moving Camera

Important Note

About Moving the

Camera

The iPower 70 camera is designed to be controlled (moved) from the collaboration system wireless keypad, the keyboard, or the remote control. Be sure that your system is turned on before you move the camera.

You should not manually move the camera from side to side (pan) or up and down (tilt).

If you manually move the iPower 70 camera head, you may experience unexpected camera pointing behavior when you use camera presets.

To correct this condition, use the wireless keypad or the remote control to do the following:

1.Press and hold the near-end right arrow button until the camera rotates as far right as it can.

2.Press and hold the near-end left arrow button until the camera rotates as far left as it can.

3.Press and hold the near-end up arrow button until the camera moves up as far as it can.

4.Press and hold the near-end down arrow button until the camera moves down as far as it can.

If the condition persists,

Power the collaboration system off and then on again.