INSTALLATION ACCESSORIES
Splitters for video signals
AV splitter Pro 1 : 3 | No. |
Signal splitter for Composite Video and Stereo Audio |
|
1 input / 3 outputs (3x3 Cinch / f) |
|
Frequency Video 430 MHz, Audio 100 kHz @ - 3dB |
|
Adjustable Audio level, Video level and cable EQ |
|
Metal casing 165x120x45 mm |
|
Power supply DC 12 V, 50 mA |
|
|
|
No. | |
1 input / 2 outputs (4 pin MiniDin / f) |
|
Frequency 150 MHz @ - 3dB |
|
Adjustable Video level (separate for Y&C) |
|
Metal casing 60x65x25 mm |
|
Power supply DC 12 V, 30mA |
|
|
|
Audio splitter Pro 1 : 2 | No. |
1 input / 2 outputs (3.5 mm jack / f) |
|
Frequency 100 kHz @ - 3dB |
|
Adjustable Audio level (separate for left & right) |
|
Metal casing 60x65x25 mm |
|
Power supply DC 12 V, 30mA |
|
Splitters for video/audio signals |
|
|
|
AV Share Basic 4 : 1 | No. 7481 |
|
|
Selector for Composite Video,
4 inputs / 1 output (4 pin MiniDin, 3 x Cinch, all f)
Composite Video - >
Plastic casing 190x115x50 mm
AV Share Basic 4 : 1 Remote | No. |
Video selector for RGB Video,
1 input / 4 outputs
(Scart RGB, 4pin
Plastic casing 60x65x25 mm
Power supply DC
Supplied with IR remote control,
36 Subject to technical alterations, as well as to changes of the design and the colour
TV Tuners / Progressive Scan Converters
TV Tuner PV500 | No. 7486 |
Converts a projector or a TFT display into a TV and Video in VGA signals (SVGA/XGA)
Can be used as TV Tuner with video text, Progressive Scan Converter, Video Scaler, VGA/Video switcher
Adaptive 2D filter for Y/C partition
Philips SAA7118 Chip
A2/NICAM Stereo Sound Decoder
Inputs: aerial / cable), Composite Video (Cinch),
Outputs: VGA (HD 15 f), Stereo jack
Output signal VGA, SVGA, XGA - 60/75 Hz
Remote control and power supply
Accessories
IR Link | No. |
Extends the range of IR remote controls.
Extension cable for IR signals sent by remote controls, consisting of:
IR receiver
Connector block with power supply 12 V DC
IR Emitter with 2 IR diodes
Cable IR receiver
Cable connector block
* Extension possible with 3pin cable
ECOMAN Beamer | No. 7487 |
Separates the projector from the mains after ca. 5 minutes of operation in standby mode. The integrated IR receiver switches the projector back to standby when it gets an IR signal. If the signal is not meant for the projector, it will be separated again.
Time controlled mains separation of projectors (after ca. 5 min. in standby mode)
High voltage protection
Max. power 460 W
Power consumption < 1 W
230 V AC / 50 Hz
Output Schuko plug