1.3Equivalent Circuit for the Input Pin of the I/O Connector
+3.3V+3.3V
On resister Max. = 30ohm
100ohm
| FVL500B1 | 5/31 |
| User’s Guide Rev. 1.01 |
| |
FVL500B1 User’s Guide Rev
FVL500B1
Table of Contents
Connector Camera Link Connector
Camera Link Connector
SDR 3M or equivalent
Pin Assignment
/ OUT
I/O Connector
+3.3V+3.3V On resister Max. = 30ohm 100ohm 10kohm
Equivalent Circuit for the Input Pin of the I/O Connector
CLK = 15.625 ns
Normal Mode Setting 10H Horizontal Timing
Vertical Timing
Normal Full Scanning Setting 10H 1XX00XXX, 11H
Partial Full Scanning Setting 10H 1XX01XXX, 11H
2.4 1/4 Partial Scanning
2.3 1/2 Partial Scanning
10H 1XX01XXX, 11H
2.5
Variable Partial Scanning Setting 10H 1XX01XXX, 11H
FVL500B1
Binning Mode Setting 10H Horizontal Timing
Setting 10H 1XX11XXX, 11H
Setting 10H 1XX10XXX, 11H
Vertical Timing Binning Full Scanning
Binning Partial Full Scanning
= 30.063 μs, 54.890 Hz
Binning 1/2 Partial Scanning Setting 10H 1XX11XXX, 11H
Binning 1/4 Partial Scanning Setting 10H 1XX11XXX, 11H
Data Order on the Camera Link Output
2TAP12bit
Pixel Transferring Image
2 Taps Transferring Image 2XE1Y )
Electric Shutter
Normal Mode
Frame Exposure
Pulse Width Trigger Mode(VReset )
Pulse Width Trigger Mode
30 CLK
Pulse Width Trigger Mode NonReset
Exposure Timing
Edge Preset Trigger Mode VReset
Edge Preset Trigger Mode
Edge Preset Trigger Mode NonReset
Reset Mode
Communication Format
Communication Settings
Communication Method
End of Frame. Always set or receive the value as 03H
Description of the format is as follows
Start of Frame. Always set or receive the value as 02H
Command to send 02H, 00H, 00H, 01H, 00H, 03H
【Example Code】Reading the data from the command 00H
Eeprom
Camera Control Command Camera Command List
25/31
Underline settings are the factory default settings
Descriptions of the Camera Control Commands
27/31
28/31
29/31
30/31
31/31