RCA ProV800C manual E01, E02, etc

Trouble Checks

Trouble	Checks and Adjustments
Back of LCD	• Light used for monitor causes it to get hot. Close the
monitor is hot	monitor or turn off the unit to cool the monitor down.
Bright spots appear	• Due to high-precision technology, black spots or bright spots
on monitor or areas	may appear on LCD monitor. These are not recorded on the
of color are not	tape.
clear	• Pressing on the surface or edge of the monitor may cause
	blurring.
Error number	• Try disconnecting power source. Wait ten seconds and then
(E01, E02, etc.)	connect power source again. If error number does not
appears on LCD	disappear from viewfinder, consult your Authorized RCA
monitor or in	Camcorder Servicenter.
viewfinder
Battery runs down	• LCD monitor requires more battery power to operate than
sooner than	the viewfinder.
expected	• If camcorder has not been used for some time, charge the
	battery using the REFRESH feature on the adapter/charger.
	• Battery run times are measured when the camcorder is
	recording continuously. You can check your battery by first
	fully charging it and then aiming the camcorder at a clock
	and recording the picture of the clock. When the recording
	stops, play the last recorded section, and note the clock time.
	A one-hour battery should give you about 60 minutes of
	recording time. In practical use, you may not be able to
	record for the full time because the camera uses battery
	current when it is waiting between recordings (record-pause
	mode) and while you focus and zoom.

87