First-Time Operation (continued)
2. Attach a power supply to the camcorder.
Attach a power supply to the
Adapter/Charger
OPEN
3.Remove the lens cap and attach it to the lens cap holder on the camcorder.
|
|
| OPEN |
|
|
| PUSH |
Pull on tab to | REC |
| Attach to |
START/ |
| ||
STOP |
| ||
remove the lens |
|
| lens cap |
cap. | SAVEPOWER | ON | holder. |
|
DC OUT
Jack
REFRESH
CHARGE
POWER
To AC
REC
START/
STOP
POWER ON
SAVE
DC IN 6.5V
DC IN 6.5V
Jack
DC Power
Cord
POWER
Indicator Jack
Pull on the tab on the side of the lens cap to remove it. Then pull it straight, rotate it down, and attach it to the lens cap holder on the side of the camcorder.
4. Attach the shoulder strap. |
1. Unfasten one end of the shoulder strap from the |
buckle. Make sure you leave the buckle on the |
Connect one end of the DC power cord into the DC OUT jack on the adapter/charger. Plug the other end of the DC power cord into the DC IN 6.5V jack on the back of the camcorder. Plug the adapter/charger’s plug into an operating outlet. The POWER indicator on the adapter/charger will light. Details are on page 16.
Charged Battery*
strap. |
2. Thread one end of the shoulder strap through |
one of the shoulder strap rings (located on the |
top and bottom of the camcorder). |
Shoulder strap rings
PUSH
REC
START/
STOP
SAVEPOWER | ON |
3.Thread the strap back into the buckle. Pull on the strap and make sure it is securely fastened before using the shoulder strap to support the camcorder.
Attach charged battery to camcorder.
Make sure the camcorder’s POWER switch is in the OFF position. Match the line on the battery to the line on the camcorder. Hold the battery flush against the camcorder and slide it in the direction of the arrow until a click is heard. Details are on page 17.
*The battery must be charged before it can be used the first time.
4.Repeat steps
(continued on next page)
9