Power Your Camcorder
Rechargeable Battery
The battery must be charged as described on the next page before it can be used the first time. Initial charging takes approximately 70 minutes. When fully charged, the battery supplies approximately
Note: Use the small marker switch on the top of the battery to help remind yourself to charge the battery. It has no other purpose.
BATTERY |
|
RELEASE | Marker |
Lever | Switch |
Battery Safety Precautions
Do not short the battery’s terminals.
Do not attempt to disassemble or modify the battery. There are no
Use the battery only with specified adapter/chargers and camcorders.
Throwing the battery into a fire or exposing it to excessive heat – over 149˚F (65˚C) could be hazardous.
Attach the Charged Battery
If the DC cable is attached to the camcorder, remove it before attaching the battery. Also, install the lithium clock cell before attaching the battery. Details are on page 17.
1.Hook the battery to the side of the camcorder as shown above.
2.Press the battery down until it locks into place.
3.Set the POWER switch to CAMERA. The power indicator lights.
Remove the Battery
Slide and hold the BATTERY RELEASE lever down while removing the battery.
ATTENTION: The EPA certified RBRC® Battery Recycling Seal on the
Cd) battery indicates Thomson Consumer Electronics is voluntarily participating in an |
|
industry program to collect and recycle these batteries at the end of their useful life, when | RBRC |
taken out of service in the United States or Canada. The RBRC® program provides a | |
convenient alternative to placing used | |
waste stream, which may be illegal in your area. Please call |
|
information on
RBRC
13