Recording
Built-In Color Enhancement Light (Continued)
Replace the Bulb Assembly
Carefully follow the instructions below.
Cautions
The video light and bulb need to cool for approximately 30 minutes after the camcorder has been used before the bulb assembly is replaced.
Do not touch the light bulb with your fingers. If the bulb is accidentally touched, wipe it with a soft cloth. A dirty bulb may cause smoke and have a reduced service life.
To Replace the Bulb Assembly
1.Insert a flat nonmetallic object (such as a plastic screwdriver) in the small hole as shown.
3.Slide the new bulb assembly into the camcorder until it is locked into place.
Plastic | Video Light |
Screwdriver |
2.Pull on the sides of the bulb assembly and remove it from the camcorder.
55