Delkin Devices SensorScope System manual Re-inspect with SensorScope, Exit sensor cleaning

After wiping once left to right and then once more right to left, flip the SensorWand over and use the dry end (Side B) to wipe any extra SensorSolution that may have accumulated on your sensor. Use the same wiping technique that you used with the wet end. (see diagram)

Caution: Be sure to only wipe your sensor as directed in these instructions; over wiping can cause damage and reapply dust accumulated on the wand during the first wipe.

Step 6: Re-inspect with SensorScope

Re-inspect your sensor with the SensorScope to make sure you did not miss anything. If you still see contaminants on your sensor, repeat step 5 using a new SensorWand.

Step 7: Exit sensor cleaning

When you are finished be sure to remove all cleaning objects out of the camera chamber and power off the camera to exit sensor cleaning mode.

Congratulations.

You now have a clean sensor and are ready to take crystal clear photographs.

11