Black Box CCTVTEST, CCTV Tester manual Operation Power and Battery, Main Menu Introduction

Page 14

CCTV Tester

3. Operation

3.1 Power and Battery

POWER: The power ON/OFF switch is located on the side of the tester.

BATTERY SAVER: The tester has a battery-saving sleep mode. Turn the slide switch ON again if the tester is asleep.

RECHARGEABLE BATTERY: The tester has a non-removable battery for a larger capacity. Do not open the rear panel and attempt to repair it.

CHARGE TIME: The battery requires five hours for a full charge.

CHARGE LED: While charging, the “Charge” LED will be ON.

OPERATING TIME: Approximately 10 hours.

WHEN TO RECHARGE: Recharge when the battery indicator in the System Setup menu shows 25% or less.

USE WHILE CHARGING: The tester can be used during charging.

3.2 Main Menu Introduction

Turn on the device. The Main Menu appears: #1 is the setup mode. #2 thru #6 selects five test modes. Use the keypad’s numbered buttons to select the menu item. The last item is the software version and serial number.

MAIN MENU

1 SYSTEM SETUP

2 VIDEO AND PTZ TEST

3 UTP CABLE TEST

4 VIDEO GENERATOR

5 RS485 DATA TEST

6MULTIMETER VER:V1.11 S/N:08110910

>Set up PTZ and check battery

>Test video and control PTZ

>Test UTP cables

>Test video monitors

>Analyze RS-485 protocol

>Measure voltage/resistance

>Software version and S/N

Figure 3-1. Main Menu.

Page 14

724-746-5500 blackbox.com

Image 14
Contents Cctv Tester Blackbox.com Normas Oficiales Mexicanas NOMElectrical Safety StatementCctv Tester NOM Statement Cctv Tester Trademarks Used in this Manual Trademarks Used in this ManualTemperature -22 to 158 F -30 to +70 C Safety Information Precautions when using the Cctv TesterPrecautions when charging the battery Table of Contents Specifications VDCFeature Description Other Work temperature SpecificationsCctv Tester specifications Features Overview IntroductionHardware Description OverviewWhat’s Included Setup PTZ test Data Power Lights When power is on Open Open LCD screen960 x 240 resolution PTZ test switchesPort RS-232 portCable test jack Operation Power and Battery Main Menu IntroductionMain Menu in order of appearance OperationQuick Test Modifying the Settings RateVideo format PAL/NTSC/NULL ADDRESS001Video Null Enter the camera’s IDUTP Remote terminatorTypical CAT5/6 Cable UTP Two 0s is a Wiremap Short circuitUTP Cable Test Tester Side Remote PIN Numbers Without cameraCctv Tester Typical hexadecimal data from an RS-485 device DC Voltage AC Voltage Resistance Tester can be used to provide power to a 12V camera Provide Power to a 12V CameraScreen Brightness Adjustment Black Box Tech Support FREE! Live /7 Copyright 2010. All rights reserved