Chauvet LED PAR 64-36B, LED PAR 64-36C user manual Safety Instructions

Page 4

Safety Instructions

Please read these instructions carefully. It includes important information about the installation, usage and maintenance of this product.

Please keep this User Manual for future consultation. If you sell the unit to another user, be sure that they also receive this instruction booklet.

Always make sure that you are connecting to the proper voltage, and that the line voltage you are connecting to is not higher than that stated on the decal or rear panel of the fixture.

This product is intended for indoor use only! To prevent risk of fire or shock, do not expose fixture to rain or moisture.

Make sure there are no flammable materials close to the unit while operating.

The unit must be installed in a location with adequate ventilation, at least 20 in (50 cm) from adjacent surfaces. Be sure that no ventilation slots are blocked.

Always disconnect from power source before servicing or replacing fuse and be sure to replace with same fuse source.

Secure fixture to fastening device using a safety chain.

Maximum ambient temperature (Ta) is 104° F (40° C). Do not operate fixture at temperatures higher than this.

In the event of a serious operating problem, stop using the unit immediately. Never try to repair the unit by yourself. Repairs carried out by unskilled people can lead to damage or malfunction. Please contact the nearest authorized technical assistance center.

Never connect the device to a dimmer pack.

Make sure the power cord is never crimped or damaged.

Never disconnect the power cord by pulling or tugging on the cord.

Never carry the fixture directly from the cord. Always use the hanging/mounting bracket. Avoid direct eye exposure to the light source while it is on.

1. Before You Begin

4

10/27/2009 1:10 PM

Image 4
Contents Snapshot Table of Contents What is included Before YOU BeginUnpacking Instructions Manual ConventionsSafety Instructions Features Additional FeaturesIntroduction Product OverviewPhotometrics Product Overview AC Power SetupPower Linking Orientation MountingRigging Cable Connectors Fixture LinkingData Cabling DMX Data CableSetting up a DMX Serial Data Link Pin to 5-Pin Conversion ChartAccessing the 2 Personalities Master/Slave Mode Sound-Active, Auto Mode, Static ColorsOperating Instructions Strobe SpeedStandalone Operation AutomaticSound-Active Static ColorsCH Mode DMX Channel ValuesGeneral Troubleshooting Setting the Starting AddressContact Us Appendix General MaintenanceDMX Primer Returns Procedure ClaimsTechnical Specifications Power