Remote Control and Motor Operation

User’s Manual

BX-AL133

The LED indicator on the sled will glow when the unit is ON, and flash when any button is pressed. It will also flash when the lens is in motion. The LED will be off in standby mode.

OFF	ON
LENS OUT	LENS IN
PANEL OFF	PANEL ON
SLOW	FAST

Buttons:

OFF – Puts the sled in standby mode.

ON –Turns the sled from standby to ON.

LENS OUT – Commands the lens to move into the LENS OUT position.

Holding the button for several seconds re-programs the current position as the new LENS IN position. The lens sled will acknowledge the request by flashing the LED and moving the lens to the new LENS OUT position (the opposite side).

LENS IN – Commands the lens to move into the LENS IN position (as configured in Setup).

PANEL OFF – Turns the logo backlight off.

PANEL ON – Turns the logo backlight on.

SLOW – Sets the acceleration/deceleration and maximum speed for slow (low inertia) traversal.

FAST – Sets the acceleration/deceleration and maximum speed for rapid traversal.

For more information, please visit our website at:	User’s Manual	10
http://www.OptomaUSA.com