Profoto D1 1000 Air, D1 500 Air, D1 250 Air manual Operating instructions

Page 13

Operating instructions

Stand mounting

1.Mount and fasten the D1 unit on the stand using the locking knob on the StandAdapter [18].

2.The unit can be directed upwards/downwards when the Locking Knob [16] is loosened. Fasten the Locking Knob [16] when the unit is correctly directed.

Mounting of external reflector

1.Unlock the clasp on the external reflector.

2.Slide the reflector onto the D1 unit. Use the Zoom Scale [17] to place the reflector in the desired position.

3.Secure the reflector by locking the clasp.

Umbrella mounting

1.Slide the umbrella shaft into the Umbrella Tube [15] on the D1 unit.

2.After a few centimeters,there will be more friction.Continue to slide the umbrella shaft to optimise the light into the umbrella.

Glass cover mounting

1.Ensure that the D1 unit is turned off and that the power cable is not connected.

2.If the unit has been in use,wait five minutes to allow the unit to be fully discharged (the autodump function).

3.Gently remove the frosted glass plate.

4.Carefully fit the glass cover in place.Make sure that the safety pins fit properly into the slot of the glass cover.

Power connection

1.Connect the power cable to the Power Supply (AC) Connector [13] on the D1 unit and to the mains power supply outlet.

2.The Power Supply Indicator [3] will be red, indicating that the unit is receiving power but is in standby mode.

3.Press the On Button [2].

4.The Power Supply Indicator [3] will now be green.

Energy level setting

1.Use the Setting Knob [7] to change the energy level of the flash light:

Turn the Setting Knob [7] clockwise to increase the energy level in 1/10 f-stop increments and counter-clockwise to decrease.

Press and hold down the Setting Knob [7] and turn the knob clockwise to increase the energy in 1 f-stop increments and counter-clockwise to decrease.

Profoto D1

13

www.profoto.com

Image 13
Contents D1 1000 Air D1 500 Air D1 250 Air Profoto D1 Thank you for choosing Profoto Safety Precautions Safety instructionsTable of Contents Profoto Air System descriptionProfoto Air Sync Profoto Air RemoteProfoto Air USB Profoto Studio AirNomenclature Slave SettingSync Connector Locking Knob Sync signaling Power supplyFunctionality Energy controlReady indicator/Test function Ready signalingFlash before ready Color temperature Remote controlReflector UmbrellaOperating instructions Ready signaling setting Modeling light settingSync via cable Radio settings D1 with Profoto AirSync via IR Sync via radio D1 without Profoto AirTurn off unit Changing flash tube and/or modeling lamp MaintenanceClasp Flash tube Modeling lamp Changing built-in fuse Adaptive thermal control 500 Air 1000 Air250 Air 500Synchronization modes Sync cable/IR/Air This page is intentionally left blank This page is intentionally left blank Change without notice
Related manuals
Manual 24 pages 12.9 Kb