Profoto D1 1000 Air, D1 500 Air, D1 250 Air manual Changing built-in fuse

Page 18

Profoto D1

18

Changing built-in fuse

1.Ensure that the D1 unit is turned off and that the power cable is not connected.

2.If the unit has been in use,wait five minutes to allow the unit to be fully discharged (the autodump function).

3.Pull out the Fuse Holder [14] from the unit and remove the old fuse.

4.Push the new fuse all the way into the Fuse Holder. Only use recommended fuse, see section Technical data.

5.Fit the Fuse Holder in place, by gently pushing until the holder snaps in place.

www.profoto.com

Image 18
Contents D1 1000 Air D1 500 Air D1 250 Air Profoto D1 Thank you for choosing Profoto Safety instructions Safety PrecautionsTable of Contents System description Profoto AirProfoto Air USB Profoto Air RemoteProfoto Air Sync Profoto Studio AirSlave Setting NomenclatureSync Connector Locking Knob Functionality Power supplySync signaling Energy controlReady signaling Ready indicator/Test functionFlash before ready Reflector Remote controlColor temperature UmbrellaOperating instructions Modeling light setting Ready signaling settingSync via IR Radio settings D1 with Profoto AirSync via cable Sync via radio D1 without Profoto AirTurn off unit Maintenance Changing flash tube and/or modeling lampClasp Flash tube Modeling lamp Changing built-in fuse Adaptive thermal control 250 Air 1000 Air500 Air 500Synchronization modes Sync cable/IR/Air This page is intentionally left blank This page is intentionally left blank Change without notice
Related manuals
Manual 24 pages 12.9 Kb