5.Feed camera leads through hole in mounting surface. Connect wires (see WIRING.)
6.Place assembled camera housing into main bracket.
7.Place dome over camera housing and attach to main bracket with 3 large screws. Do not tighten completely.
Figure 4
Use 1/2" Screws
8.Make provisions to view the camera image and point the camera at the desired location. Note: Make sure image is level!
9.With camera properly aimed, tighten screws.
Figure 5
WIRING
1. Adjust view
2.Tighten screws
NOTE: THE
Figure 6
RG6 or
RG59
Coax
To video display, | Male RCA to |
female F | |
Z880, MOD3000 etc. | connector |
12VDC |
|
|
|
Stripe = + | – | Black |
|
+ |
| Supplied with | |
| Red | ||
|
|
|
4 | Remove |
|