ENGLISH
Advanced Recording
ZERO MEMORY
✤The MEMORY function works in both CAM and VCR modes.
✤You can mark a point on a tape that you want to return to following playback.
1.Press the ZERO MEMORY button on the Remote Control during playback or recording at the point you wish to return to.
■The time code is changed to a tape counter that is set to zero memory with the M 0:00:00(Zero memory indicator)
■If you want to cancel the zero memory function, press the ZERO MEMORY button again.
2.Finding the zero position.
■When you have finished playback, fast forward or rewind the tape.
-The tape stops automatically when it reaches the zero position.
■When you have finished recording, press the power switch on the VCR and press the 
(REW) button.
-The tape stops automatically when it reaches the zero position.
3.The tape counter with the M (Zero memory indicator) disappears from the display and the tape counter is changed to the time code.
Notes
■In the following situations, ZERO MEMORY mode may be canceled automatically
-At the end of the section marked with the ZERO MEMORY function.
-When the tape is ejected.
-When you remove the battery pack or power supply.
■The zero memory may not function correctly where there is a break between recordings on the tape.
■The ZERO MEMORY will not operate in DV IN mode.
70