
Menu Setup
Use the six Setup Menu buttons on the rear of the camera.
Menu Setup Switch
ESC | FL | BLC ATW VIDEO | INT | ① Electonic Shutter speed Control | : OFF | |||
② Flickerless | : OFF | |||||||
|
|
|
|
|
| |||
|
|
|
|
|
| ③ Backlight Compensation | : OFF | |
|
|
|
|
|
| ④ Auto White Balance | : ATW | |
|
|
|
|
|
| ⑤ LENS Selection | : VIDEO | |
|
|
|
|
|
| ⑥ Sync Mode | : INT | |
OFF | ON | OFF AWC DC | LL | |||||
|
|
|
|
|
|
Function of Menu Setup Switch
①ESC (Electronic Shutter Control)
You can turn ESC or OFF the Electronic Shutter Control feature.
This ESC mode automatically controls the shutter speed from‘1/60’ to‘1/100,000 ’sec (NTSC), from‘1/50’to‘1/100,000’sec. (PAL)
If you want to use DC or VIDEO lens, confirm this switch turn OFF. (Electronic shutter is fixed in‘1/60’sec. (NTSC) or‘1/50’sec (PAL)
②FL (Flickerless)
Flickerless function. In this function, electronic shutter is fixed in
‘1/100’sec(NTSC) or‘1/120’sec(PAL)
FL function can compensation the flicker caused by power
frequently, but set off in the area not using a 60 Hz AC power on NTSC.
③BLC (Backlight Compensation)
When the lighting source in the rear of object, the object might be seen some darkness. If you want to see object clearly, turn this switch BLC. The effective area where backlight compensation is fixed in the center of the screen.
If you want to use DC or VIDEO lens, confirm this switch OFF.
0 5 10 15
0
7
13
15
④White balance control mode
1)ATW (Auto Tracing White balance) : The camera automatically controls the white balance in any environment.
2)AWC (Auto White balance Control) : The White balance is automatically adjusted in a specific environment.
•Pleace select ESC OFF that chroma mav be chance periodicallv because of ATW movement under the fluorescent lights indoor.
⑤Lens selection
1)Manual Lens
Set Menu Setup switch ESC
2)Auto IRIS Lens
ⓐVIDEO Lens : Set the ESC OFF in Menu Setup switch, and turn DC/VIDEO selection switch VIDEO.
If you need, adjust the brightness of the screen of the screen with adjustment VR(ALC, LEVEL) on the VIDEO lens.
ⓑ DC Lens | : Set the ESC OFF in the Menu Setup switch, and |
| the DC/VIDEO selection switch DC. |
| It may necessary to adjust the bright of the screen. |
| If you needs, handle the DC LEVEL the rear of the |
| camera. |
⑥INT/L.L (Synchronization System Mode)
Two synchronization modes are available. In L.L mode, Use V.Phase adjust relation between the zero crossing point of AC power wave and V─Sync Pulse of the camera's video signal.
The V.Phase has been set at 220 degrees and can be readjusted in the range of 0 to 270 degrees as need.
L.L mode can be used in 60Hz
50Hz
⑦AGC (Auto Gain Control) Always on.
18 | COLOR CCD CAMERA | COLOR CCD CAMERA | 19 |
|
|
|
|