Yamaha NS-P220 Problem Cause What to Do No sound, Sound level is too low, Automatically

TROUBLESHOOTING

Refer to the chart below when this unit does not function properly. If the problem you are experiencing is not listed below or if the instructions given below do not help, disconnect the power cord and contact your authorized YAMAHA dealer or service center.

Problem	Cause	What to Do
No sound.	Speaker cords are not connected	Connect them securely.
	securely.
Sound level is too low.	Speaker cords are not connected	Connect them correctly, that is L (left) to
	correctly.	L, R (right) to R, “+” to “+” and “–” to “–”.

For SW-P201

Problem	Cause	What to Do
Power is not supplied even	The power plug is not securely	Connect it securely.
though the POWER switch is set	connected.
to the ON position.
No sound.	The VOLUME control is set to 0.	Turn the VOLUME control to the right.
	Speaker cords are not connected	Connect them securely.
	securely.
Sound level is too low.	Speaker cords are not connected	Connect them correctly, that is L (left) to
	correctly.	L, R (right) to R, “+” to “+” and “–” to “–”.
	A source sound with few bass	Play a source sound with bass
	frequencies is played.	frequencies.
	It is influenced by standing waves.	Reposition the subwoofer or break up
		the parallel surface by placing
		bookshelves etc. along the walls.
The subwoofer will not turn on	The POWER switch is set to the OFF	Set the POWER switch to the ON
automatically.	position.	position.
	The AUTO STANDBY switch is set to	Set the AUTO STANDBY switch to the
	the OFF position.	“HIGH” or “LOW” position.
	The level of input signal is too low.	Set the AUTO STANDBY switch to the
		“HIGH” position.
The subwoofer turns into the	The level of input signal is too low.	Set the AUTO STANDBY switch to the
standby mode unexpectedly.		“HIGH” position.
The subwoofer turns on	There is an influence of noise	Move the subwoofer farther away from
unexpectedly.	generated from external appliances etc.	such appliances and/or reposition the
		connected speaker cables.
		Otherwise, set the AUTO STANDBY
		switch to the “OFF” position.

13