2.Tighten the camera brace up against the camera to secure it into place.
3.Unlock the mounting post by turning the wingnut to the left a few turns.
4.Set the mounting post to the correct angle, then tighten the wingnut until the post is locked into place.
5.Attach the antenna to the rear of the camera.
6. Connect one end of an AC adapter to the camera’s | Antenna |
power pigtail and plug the other end into a 120 volt |
|
AC (standard indoor) power outlet. (If necessary, |
|
connect the extension cord to the camera’s pigtail |
|
and connect the AC adapter to the extension cord.) |
|
Be sure the power plug and the connector are tightly twisted together to avoid water leaking in.
7. Make sure the Power status light turns on. If it doesn’t, try reconnecting the AC adapter, and make sure the power outlet isn’t controlled by a wall switch.
8. You should now have video on your Live screen.
SETTING UP YOUR SYSTEM
You can now set your cameras and system to your preferred settings.
Camera Settings
••
••
••
Brightness (“Uniden Guardian Settings Screen” on page 21) Motion Detection (“Uniden Guardian Settings Screen” on page 21) Schedule Recordings (“Schedule Record” on page 28)
System Settings
•• Power Saving (“Power Saving” on page 34)
11