Fujitsu fi-4640S manual Contents of the Setup Mode

Contents of the Setup Mode

This section describes the contents of the setup mode.

No	Item	Description	Selectable	Default
			parameters
		Specifies the double feed detection. Double
1	Double feed check	feed is detected by checking the document	No/Yes	No
		length and/or paper thickness.**
	Length check	Specifies the document length to enable	Tolerance:
2		double feed detection sets the document		No
	=No/10/15/20 mm		No/10/15/20mm
		length.
		Scanner automatically sets the	Document:
			No
		recommended reading parameters. 3 sets
3	IPC pre-setting		1: Sharpen	No
		of parameters are available when IPC-4D is
		not installed.	2: Darken Character
			3: Copy Quality
4	Resetting of	Resets the abrasion counter.	---	---
	abrasion counter
	Pick start time	Specifies the time from document Insertion	Time:
5		to the start of picking. User can select the		1.0 sec
	setting		0.2 to 29.8 sec
		most comfortable Pick start time for the job.
		Specifies the time the scanner waits for the	Time:
6	Time-out limit setting	next document insertion after the last	27 values from	30 sec
		document was scanned.	1 to 1999 sec
		Specifies the horizontal and vertical offset	Offset:	Offset:
7	ADF offset setting*		H:-2 to +3 mm	H: 0 mm
		of the image when using the ADF.
			V:-2 to +3 mm	V: 0 mm
	Flatbed offset	Horizontal and vertical offset of the FB	Offset:	Offset:
8			H:-2 to +3 mm	H: 0 mm
	setting*	image is specified.
			V:-2 to +3 mm	V: 0 mm
9	Option (IPC/Imprinter)	Displays the type (IPC-4D) of the IPC	---	---
	status display	option. "IPC PRT" is displayed when the
		fi-475PR Imprinter Option is installed.
		The SCSI ID is selectable. Note that the	SCSI ID:
10	SCSI ID setting	new setting is made valid after power is		5
			0/1/2/3/4/5/6/7
		turned off and on again.
11	SCSI terminator	Switches the SCSI terminator On/Off.	On/Off	On
	setting
12	Low Power Mode	Changes the default setting of the duration	5 min.	15 min.
	setting	for power save.	to 60 min.

7-2