Toshiba IK-WD14A quick start Do not aim the camera at the sun, Do not shoot intense light

Page 8

Notes on Use and Installation

Do not aim the camera at the sun

Never aim the camera at the sun even with the camera power off.

Do not shoot intense light

Intense light such as a spotlight may cause a bloom or smear. A vertical stripe may appear on the screen. However, this is not a malfunction.

Treat the camera with care

Dropping or subjecting the camera to intense vibration may cause it to malfunction.

Never touch internal parts

Do not touch the internal parts of the camera other than the parts specified.

Keep the camera installation away from video noise

If cables are wired near electric lighting wires or a TV set, noise may appear in images. In this event relocate cables or reinstall equipment.

Check the ambient temperature and humidity

Avoid using the camera where the temperature is hotter or colder than the specified operating range. Doing so could affect the internal parts or cause the image quality to deteriorate. Special care is required to use the camera at high temperature and humidity.

Should you notice any trouble

If any trouble occurs while you are using the camera, turn off the power and contact your dealer. If you continue to use the camera when there is something wrong with it, the trouble may get worse and an unpredictable problem may occur.

8

Image 8
Contents Model IK-WD14A Introduction FCC USA-INFORMATIONTerms and Trademarks Table of Contents Important Safeguards Damage Requiring Service Other trouble. Replacement PartsSafety Check LightningField Installation Marking Keep the camera installation away from video noise Check the ambient temperature and humidityDo not aim the camera at the sun Do not shoot intense lightAdministrators personal computer Items needed for network camera monitoringContents Physical Description Status LED Hardware Installation Bottom Camera Dome CoverCable installation Mounting the camera to a solid surfaceNetwork Deployment When using a PoE-enabled switchWhen using a non-PoE switch General Connection without PoE Assigning IP Address Retrieving Images Adjusting the Lens To adjust the viewing angleDome cover Adjusting the Zoom and Focus To adjust the zoom factor and focus rangeToshiba America Information SYSTEMS, INC
Related manuals
Manual 123 pages 45.01 Kb