White BAL, Focus Mode, Motion DET | Samsung SCC-C4305(P) specification

❙WHITE BAL

You can select one of four modes for white balance adjustment as follows:

-ATW1/ATW2(Auto-Tracing White Balance Mode): In these modes, the color temperature is monitored continuously and thereby white balance is set automatically. The following are the approximate supported color temperature ranges in these modes.

ATW1 : 2500K ~ 9300K(✻1)

ATW2 : 2000K ~ 10000K(Mode recommended for sodium lighting)(✻2)

✻1. If the color temperature is out of this range in ATW1 mode, proper white balance may not be obtained. In that case, select ATW2 mode.

✻2. In ATW2 mode, if one color is dominated in the shooted area, the color can be displayed differently. Therefore, select the mode which is appropriate for the environment.

-AWC(Auto-Tracing White Balance Control): In this mode, accurate white balance is obtained by pressing [ENTER] while having a white paper in front of the camera. White Balance data will be maintained after set it once. AWC mode is best in locations where the color temperature of light source is constant.

-MANU : If WHITE BAL menu is set to MANU mode, the user can set the white Balance considering the current illumination. Select MANU item and press [ENTER], the sub screen where you can select Manual White Balance will be shown. Use the left/right keys to select 3200K, 5600K or OFF(USER) mode in the PRESET menu.

✔3200K : Set color temperature to 3200K

✔5600K : Set color temperature to 5600K

✔USER : Choose out a proper value from the RED and BLUE graph for color and temperature setup.

(MANU)
(MANU)
	OFF(USER)
PRESET	OFF(USER)
RED	(80) - - --	I - - - -
BLUE	(80) - - - -	I - - - -
RET

❙FOCUS MODE

The FOCUS MODE menu performs AF(Auto Focus), MF(Manual Focus), and ONEAF(One Auto Focus).

✔AF : Focuses automatically by continuously monitoring the screen in AUTO FOCUS mode. It does not process the FOCUS button input because it focuses automatically during ZOOM.

✔ MF : You can manually adjust the focus.

✔ONEAF : Focuses about 5 seconds only when ZOOM is moved Wide to Tele. It is same as MF mode while in STOP

mode, and same as AF mode after ZOOM Tele.

	CAMERA ID		OFF
	CAMERA ID		OFF
	IRIS		ALC...
	SHUTTER		OFF
	AGC		LOW
	WHITE BAL		ATW1
	FOCUS MODE		AF
	MOTION DET		OFF
	COLOR/BW		COLOR
	PRIVACY		OFF
	SPECIAL		...
	PRESET		...
	EXIT		QUIT

❙MOTION DET

MOTION DET detects any motion. Set up this function during no human movement to detect break-in. Once detected, an ALARM signal will be given for 5 seconds. As MOTION DET detects any motion, so it can set up the motion detection sensitivity. Select ON... and press [ENTER] and the MOTION DET submenu screen will appear.