Polycom Ceiling DocCam user manual Unpacking, Important safeguards, BNC to RCA

Page 3

2

Ceiling DocCam II — Introduction

Unpacking

Ensure that you received the following parts:

Ceiling DocCam

Trim Ring

Camera Enclosure

Single Wallplate

Manual

 

 

 

 

PRESETS

 

0

1

2

3

4

5

- +

25' S-video Cable

50' Cat. 5 Cable with

BNC TO RCA

Remote

 

RJ-45 Jacks

Adapter

 

 

Triple-A

6-32 X 1/2 Oval

 

Tile Support Rail

batteries (2)

Head (White)

Power Supply

Figure 1. Unpacking items

Note: ClearOne is not responsible for product damage incurred during shipment. You must make claims directly with the carrier. Inspect your shipment carefully for obvious signs of damage. If the shipment appears damaged, retain the original boxes and packing material for inspection by the carrier. Contact your carrier immediately.

Ceiling DocCam II — Introduction

 

3

 

Important safeguards

Read and understand all instructions before using.

Do not operate the Ceiling DocCam II if the power cord is damaged or if the Ceiling DocCam II has been dropped or damaged. A qualified service technician must examine the Ceiling DocCam II before operating.

Do not attempt to take the Ceiling DocCam II apart.There are no user-serviceable components inside.

Clean exterior of Ceiling DocCam II by wiping with a clean, damp cloth; do not use abrasive chemicals.

Do not store or operate the Ceiling DocCam II under the following conditions:

~A temperature above 104° F (40° C) or below 32° F (0° C)

~Environments with high humidity

~Dusty environments

~In inclement weather

~Under severe vibration

Attention: Use only the power supply provided with the Ceiling DocCam II. Use of any unauthorized power supply will void any and all warranties.

Attention: Laser radiation is present. To avoid eye damage, do not stare directly into laser beam.

CAUTION

LASER RADIATION

DO NOT STARE INTO BEAM

CLASS II LASER PRODUCT

Technical Services Group ~ 1-800-283-5936 (USA) ~ 1-801-974-3760

Technical Services Group ~ 1-800-283-5936 (USA) ~ 1-801-974-3760

Image 3
Contents Page Introduction Table of ContentsImportant safeguards UnpackingBNC to RCA Product overview Camera enclosureFront and back wall plate connections Remote InstallationBefore you install Mounting the cameraTo connect to the display device and control system Connecting cablesTo mount the camera To connect to the wall plateConfiguring for remote controls Programming presetsTo program a preset Viewing areas Using your codec remoteUsing your ClearOne remote OperationTroubleshooting SpecificationsAppendix Product Return and Repair WarrantyStandards to which Conformity is declared FCC Part 15/ICES-003 ComplianceEuropean Compliance EC Declaration of ConformityOverview of Visca Visca Communication SpecificationsVisca Command/ ACK Protocol RS-232 control informationNetwork Change Message Visca Camera-Issued MessagesError Messages ACK/Completion MessagesON/OFF CamwbATW CamaeINT Inquiry Command Comments Block Inquiry Command ListGain H Other Inquiry Commands ... Command Packet 8x 09 7E 7E 02 FF Byte Bit Comments Close Visca Command Setting ValuesExposure control Ntsc PALLens Control Zoom Ratio and Zoom Position for reference