Fig-5, Fig-6, Fig-7, Fig-8 | Sanyo LNS-W31A, LNS-T32, LNS-T31A

3REMOVE THE LENS (See Figure-5 and 6)

1. Remove the connector "K16J" of the circuit board. Remove the lens motor lead from lead holder.

2.Remove screws-C (4 screws) which fastens the lens and remove the lens. Use the driver (3 mm, Green) included with the lens to remove the screws.

Be careful not to drop the lens when removing the screws.

After using, save the driver for latter use.

4MOUNT THE LENS (See Figure-5 and 6)

SCREW "C"

LENS LEAD (Part No. 412 062 3705)

MOTOR HOLDER

LENS MOTOR LEAD

CONNECTOR "K16J"

Fig-5

1. Remove protective caps (front and back) on the lens.

2.Mount the lens on lens mounting bracket with 4 screws. (locate motor on left side).

Use the driver (4 mm, Yellow) included with the lens to fasten the screws.

After using, save the driver for latter use.

3. Connect the lens motor lead to the connector "K16J" of the circuit board.

4.Connect the lens motor lead to the lead holder.

DRIVER

IN THE LENS

LENS MOUNTING

BRACKET

Fig-6

5MOUNT THE LIGHT-BLOCK SHEET BASE

(See Figure-7)	LIGHT-BLOCK
	SHEET BASE

1. Mount the light-block sheet base to the projector.

6MOUNT THE LIGHT-BLOCK SHEET AND LENS COVER (See Figure-8)

Fig-7

1. Mount the light-block sheet to the light-block sheet base as shown in the Figure-8. (In the same position as the removed sheet has been placed). Use the sheet included with the lens.

2.Make sure the part no. and mark (TOP and BACK) on Light-Block Sheet and set them properly.

3.Mount the lens cover with the screws.

LIGHT-BLOCK

SHEET

LENS COVER

Fig-8

-3-