| GETTING STARTED | AdvancedTechnologyVideo,Inc. | | |
| Camera | Configuration |
| QSP-660 | | |
| | | |
| Camera | | | | |
| | | | | |
| Camera | | | Alarm Inputs | |
| Camera | | | | | |
| | | | | VCR | |
| | Optional for VCR | (Optional) | Alarm Out | |
| | | |
| | recording | 10K | | OUT | IN |
| | changes | | |
| | VCR-IN | | | | |
| | VCR OUT | | | | |
| | VIDEO OUT | | | | |
| | | | Monitor | |
The above diagram shows the typical 4-camera installation for the QSP-660. Up to four cameras can be connected to the real time quad using the back panel connectors.
Note: The VCR and monitor connections must be as shown above for proper operation.
Installation Steps
The following steps should be followed to ensure proper connection and set up of your QSP-660. A diagram showing the overall connection configuration of the QSP-660 is shown above.
The installation steps are:
1.Connect your cameras, monitor, and VCR (if recording is necessary) to the QSP-660. Refer to the “Back Panel Connections” and “Video Line Termination Switches” section on page 5 for proper connections and switch settings for your particular installation.
2.Power up the QSP-660, then enter the QSP-660 set up menus by pressing and holding the DISPLAY button for approximately 3 seconds. Refer to the Set Up menus section of the manual starting on page 8. Set the current time and date in the QSP-660 using the Set Time/Date menu.
3.Exit the QSP-660 menus by pressing the DISPLAY button to exit each menu and finally the menu system.
QSP-660: Instructions for Basic Operation and Installation | Page 4 |