Advanced Global Technology QSP-660 manual Hand Held IR Remote Control, Code set #1 Code set #2

AdvancedTechnologyVideo,Inc.

HAND HELD IR REMOTE CONTROL

The hand held remote control allows easy remote operation of your QSP-660 by duplicating the front panel buttons as shown in the diagram. One major difference between front panel and remote operation is that the individual camera buttons have been reduced to a single button. In this case, the first press of the camera button will cause the QSP-660 to display camera 1. Additional button presses will cycle the selection through each available camera and back to camera 1.

Please note that the remote control may not work properly in the presence of strong sun light.

Programming your ATV QSP-660 Remote Control

When first installing or when changing the batteries in your QSP-660 Remote

Control, it may be necessary to reprogram it for use with the

QSP-660.

Note: If your remote control does not appear to work for any reason, please perform the following steps.

To program the remote control to work with the QSP-660:

1.Ensure that batteries are properly installed in the QSP-660 Remote Control.

2.Turn on the QSP-660 and connect a monitor.

3.On the QSP-660, press the DISPLAY button to return to DISPLAY mode. Then press any of the 1-4buttons to call up a full screen picture.

4.On the remote control, press and hold the VCR button followed by the DISPLAY. Hold both buttons together until the indicator lights up and blinks twice.

5.Enter your five-digit code. The QSP-660 code set #1 equates to remote code 11414, and code set #2 equates to code set 11344. The red LED will now blink twice and the remote control is set. Your QSP- 660 is factory set for Code set #2. See page 16 to change the QSP-660 Code set.

The codes are entered by using the four buttons shown in the above diagram (Freeze, Camera, Quadrant, PIP). For example, to enter the default code for a QSP-660 (code 11344) press the following:

Code set #1		Code set #2
FREEZE	2 TIMES	FREEZE	2 TIMES
QUADRANT	1 TIME	PIP	1 TIMES
FREEZE	1 TIME	QUADRANT	2 TIMES
QUADRANT	1 TIME

Press the DISPLAY button on the remote control for quad display on the QSP-660.

Note: After replacing the battery, you must re-program the remote.

QSP-660: Instructions for Basic Operation and Installation Page 17