NAD C 325BEE Troubleshooting, Problem, Cause, Solution, No Sound One Channel, Not Working

PRESS IN AND LIFT TAB TO REMOVE	PLACE BATTERIES INTO OPENING. ENSURE	REPLACE BATTERY COVER BY ALIGNING AND
BATTERY COVER OUT FROM RECESS	THE CORRECT POLARITY IS OBSERVED	INSERTING THE TWO TABS INTO THE HOLES.
		PRESS BATTERY COVER INTO PLACE UNTIL IT
		'CLICKS' CLOSED

	TROUBLESHOOTING
	PROBLEM		CAUSE		SOLUTION
NO SOUND		•	Power AC lead unplugged or power not	• Check if AC lead is plugged in and power
			switched on		switched on
		• Tape 1 Monitor selected		• De-select Tape 1 Monitor mode
		•	Mute on	•	Switch off Mute
		• Rear Pre-out/Main-in amp links not fitted		•	Fit links
		•	Headphones inserted	•	Disconnect headphones
NO SOUND ONE CHANNEL		•	Balance control not centered	•	Center Balance control
		• Speaker not properly connected or damaged		• Check connections and speakers
		• Input lead disconnected or damaged		• Check leads and connections
WEAK BASS / DIFFUSE STEREO IMAGE		•	Speakers wired out of phase	• Check connections to all speakers in the system
REMOTE CONTROL HANDSET		•	Batteries flat, or incorrectly inserted	• Check or replace batteries
NOT WORKING
		• IR transmitter or receiver windows obstructed		•	Remove obstruction
		• IR receiver in direct sun or very bright ambient		• Place unit away from direct sun, reduce amount
			light		of ambient light
POWER/PROTECTION LED TURNS RED		•	Amplifier has overheated	• Turn amplifier off, make sure ventilation slots on
DURING OPERATION					top and bottom of amplifier are not blocked.
					After amplifier has cooled down, turn back on
		• Overall impedance of loudspeakers too low		• Ensure the overall loudspeaker impedance is not
					below 4 ohms

SVENSKA PORTUGUÊS ITALIANO ESPAÑOL NEDERLANDS DEUTSCH FRANÇAIS ENGLISH

9