SVAT Electronics CVQ1000 user manual Motion setup

Page 9

E. Motion setup:

yCamera 1: Choose desired camera.

yDetection Time: To enable / disable detection of the cameras.

yMasking area: To disable some area you wish not to detect.

yTo exit, press MENU button again.

F. Event setup & Event report:

yLoss: If any camera loss its signal, the report will go to Event report.

yMotion: Any motion detected in front of camera, the report will go to Event report.

yBuzzer hold time: To enable or disable buzzer function and can be set from OFF to 99 sec..

yReport hold time: To enable or disable the report function and can be set from OFF to 99 sec.

y6 pages of "EVENT REPORT" are available in this system.

yReport can be deleted by choosing "YES" on LIST CLEAR section.

yTo exit, press MENU button again.

yPress any button except "OK" on the switch box to clear the alarm noise.

yAlarm / Alarm Polarity: To enable the Power-On alarm, all 4 alarm checks should be ticked together with Alarm Polarity to be set "High".

Image 9
Contents Wired Color Camera with Quad Processor & Remote Control Page Camera Installation Installation and AdjustmentParts Included with This System Parts of the SystemSwitcher Installation System FeaturesFront panel Description Of ControlFunctions of Control Buttons Remote ControlRemote Control Functions Menu SetupPress Menu to setup the menu at any mode System setup Motion setup NTSC/PAL Product Specification