Elite 3X Vandal Dome Cameras
Overview:
Service
monitor port
| Set screw |
Dome | Rubber ring |
OSD joystick
Camera | BNC |
|
connector |
| |
|
| |
|
| Base |
|
| (For surface mounting only) |
DC Plug to |
| Important: |
| Do not cut the DC jack or the female BNC | |
terminal block DC Jack | connector as this will void the warranty. | |
Before Starting:
1.Please read this manual carefully and keep it for future reference.
2.Use the camera within given temperature and electrical limits.
3.Do not aim the LEDs directly at the eyes when the LEDs are on.
4.Do not point the camera at the sun. Heat could damage the camera, even when not in use.
5.Do not mount the camera in areas exposed to radiation, strong magnetic fields, or strong electrical signals.
6.Do not open or disassemble the camera. There are no
7.Do not drop the camera or subject it to strong vibrations.
Installation:
1.Run hidden cables from the video source and power supply and connect to the camera. Do not cut the DC jack or female BNC connector as this will void the warranty. If needed, use the included
2.Test the voltage from the power supply. Use 12VDC or 24VAC.
3.Undo the hex screws on the side of the dome using the included allen wrench and remove the dome and the rubber ring from the camera and base.
4.For surface mounting:
Hold the camera against the wall, ceiling, or other mounting surface while watching the monitor to find the best mounting location. Mark that location with a pencil. Mount the base to the wall or ceiling using the four included mounting screws. If the wall is made of brick, drywall, or similar material, it may be necessary to use screw anchors (not included).
Mount the camera to the base using the
For flush mounting:
Use the included mounting template as a guide to drill the necessary holes. Insert the camera into the hole. Mount the camera to the wall using the four included mounting screws.
5.Adjust the camera angle as needed. Use the OSD control joystick to adjust the camera settings (See the OSD manual). Connect a service monitor to the service monitor port connector for
6.To adjust zoom and focus, loosen the lock knobs by hand or with a screwdriver. Slide left or right to adjust. Do not use power tools. Lens damage may result
7.Replace the rubber ring on the camera.
8.Reattach the dome to the camera.
9.Use the included allen wrench to tighten the set screw, securing the dome to the base.
10.Do a final test of the video camera and monitor.
3 |