ENFORCER BALL-MOUNT IR DOME CAMERA Manual
ENFORCER
Specifications |
|
|
|
Type | Color camera |
|
|
Chip | 1/3” CCD, Sony |
|
|
Resolution | 420 TV lines |
|
|
Pickup elements | 510 x 492 pixels |
Scanning system | 2:1 interlace, V: 59.94Hz, H: 15.734KHz |
Sync | Internal |
| To BNC |
| |
(From DC | |
Camera) |
|
Parts List
1 x Camera Ball
1 x Case
1 x Base
3 x Screws
1 x Manual
Video output | 1V pp composite output, 75 ohms |
Lens | F1.2, 3.6mm (lens included) |
IR LEDs | 24 x LEDs |
IR distance | Up to 50’ (15m) |
IR view angle | 50o~80o beam spread, 30o per LED |
Minimum illumination | 0.05 lux, (0 lux with IR on) |
Gamma correction | 0.45 |
S/N ratio | >50dB |
Shutter control | Auto Electronic Shutter (AES), 1/60~1/100,000 sec. |
Backlight compensation | Auto |
Automatic gain control | Auto |
White balance | Auto, 2500o ~ 9500oK |
Power source | 12VDC ±10% |
Power consumption | 70mA (IR off), 280mA (IR on) |
Storage temperature |
Power
3 xConnector
Screws
BNC
Connector
| Case | Camera |
|
Case | Ball | Base | |
|
|
Operating temperature | 14°~122° F |
| |
Dimensions | 311/16” x 211/16” (93 x 69mm) |
| |
Weight | 6.3 oz. (180g) |
| |
Dimensions: |
|
|
|
|
|
| |
BEFORE STARTING
1.Please read this manual carefully and keep it for future reference.
2.Use the camera within given temperature and electrical limits.
3.Do not mount the camera where it is exposed to rain or other moisture, or in humid or dusty places.
4.Do not point the camera at the sun. Heat could damage the camera, even when not in use.
5.Do not mount the camera in areas exposed to radiation, strong magnetic fields, or strong electrical signals.*
6.Do not open or disassemble the camera. There are no user- serviceable parts inside.
7.Do not drop the camera or subject it to strong vibrations.
*Note: Many video monitors produce strong electromagnetic fields close to the display CRT, especially when the monitor is turned on or during
211/16”
(69mm)
311/16” (93mm) 
INSTALLATION
1.Run a 12VDC power supply wire and a video cable with a male BNC connector through the wall to where the camera is to be mounted.
2.Temporarily connect the camera to the 12VDC power supply.
3.Temporarily connect the camera’s female BNC connector to the video cable’s male BNC connector.
4.While watching the monitor, hold the camera against the wall by hand where it is to be mounted, then turn the camera until it is certain that this mounting location is correct. Use a pencil to mark the location of the three screw holes in the base.
5.Disconnect the 12VDC power supply and video cable.
6.Mount the bracket to the wall using the three included mounting screws. If the wall is made of dry wall, brick, or similar material, it may be necessary to use screw anchors (not included).
7.Reconnect the 12VDC power supply and video cable. Turn the monitor on, and make sure the camera is sending the proper video signal.
8.Adjust the camera angle.
9.Put the case over the camera ball and twist to secure to the base.
10.Do a final test of the video camera and monitor.
*Note: The base also allows