Connecting the camera to a computer | Trust Computer Products 1290Z

TRUST 1290Z POWERC@M OPTICAL ZOOM

Enlarging photos

You can use the Zoom buttons (T)/(W) to display a photograph in more detail. The default zoom setting is 1.0x

Press the zoom-in button (T) to increase the zoom factor from 1.0x to 4.0x in 1.0x increments. Press the zoom-out button (W) to reduce the zoom factor/

You can use the “Ç“, “Æ”, “È” and “Å” buttons to browse through the photos.

Thumbnails

Press the “DISPLAY” button until the thumbnails are shown on the LCD display.

In Thumbnail Review mode up to nine photographs are displayed simultaneously on the LCD display. You can use the “Ç“, “Æ”, “È” and “Å” buttons to browse through the thumbnails.

To return to Full-Screen view select the required photo and press the “ENTER” button. The selected picture will then expand to fill the entire LCD display.

Video recordings

Press the “ENTER” button to start the playback of the video. Press the “ENTER” button to interrupt the playback of the video. Press the “ENTER” button again to continue the playback.

Whilst the playback is interrupted you can use the “Å” and “Æ” buttons to browse to the previous/next shot.

Erasing an image

1.Select the image you wish to erase

2.Press the “MENU” button.

3.Select [ERASE SINGLE IMAGE]

4.Press the “ENTER” button.

5.Select [YES] and press “ENTER” to erase the image.

6.Press the “MENU” button to return to the normal playback mode.

N.B.:you cannot erase images which are protected or set ready for printing.

10.2Connecting the camera to a computer

This Section explains how the camera can be connected to a computer for the transfer of images.

Before you connect the camera to the computer you must complete the following steps:

1.	Install the driver (only for Windows 98)	Section 10.2.1
2.	Connecting the camera to a computer	Section 10.2.2
3.	Copying photos/video-clips to the computer	Section 10.2.3

10.2.1Installing the driver (only for Windows 98)

N.B.:do not connect the camera to your computer before you install the driver.

1.Insert the CD-ROM in your computer’s CD-ROM drive. The installation program will start automatically. If it does not start automatically, carry out the following:

a.Select 'Run' from the Windows Start menu.

b.Key in [D:\setup.exe] and click ‘OK’